The FMD红包雷群规则大全 (Fix My Duck) is a three-in-one pedal.
- 1. Can function as a buffer pedal. Converts the guitar’s output into a low-impedance signal.
- 2. Can function as treble booster pedal. It's absolute magic at producing clarity and presence in solos even when the guitar has a ton of bottom, or when using amps that become bloated sounding when slammed hard.
- 3. Can function as a full-range booster pedal. This mode is used to drive the front end of an amp and push the amp into its own natural overdrive.
The FMD红包雷群规则大全 is a pedal designed for guitar players.
It evolved from a circuit that was designed for a luthier who needed an acoustic pre-amp for his 12-sensor pick-up system. When working on this acoustic preamp circuit I was looking for something different and special, so I turned to my good friend Kevin O’Connor at London Power for some guidance on this project. I am happy to say, Kevin had some great ideas and steered me in the right direction. The basic circuit I finally settled on uses Jfets. Tuned properly, it can compress in a “tubish”-sounding way (organic) when pushed into clipping.
红包雷群规则大全i also used a version of this circuit in my k2 buffer pedal, ideal for retaining tonal integrity when driving long instrument cables.
After some experimentation, I found that cascading several of these circuits together created a very pleasant-sounding booster pedal. After another year of building one-off prototypes to get the circuit tonally worked out, the FMD pedal was born.
How it's built:
Each FMD is hand painted and labeled by Kristine (my daughter).
The FMD uses a high-quality circuit board (board designed by Kevin O’Connor of London Power).
components are selected for tone as well as reliability.
红包雷群规则大全each pedal is hand drilled.
each pedal is hand wired.
Sens. – Controls the FMD’s level of gain and compression. Higher settings are brighter and more compressed, while low settings are darker with less compression.
Level – Controls the output level.
Tone – Controls the high frequency.
Footswitch – Is a true by-pass switch.
In – Input jack for guitar.
Boost switch: –
Middle position is flat, buffer mode.
Down position is treble boost mode.
Up position is full range boost mode.
Out – 红包雷群规则大全Output to amplifier
Thin position is used to cut some bottom frequencies.
Thick position is full range.
9 volt adaptor - 2.1 mm connector, center is negative.
红包雷群规则大全-accepts industry-standard 9-volt regulated power supply.
Interested in an FMD Booster Pedal? See our Price Page for ordering information!